extreme networks

Extreme Networks Loopback detection on ports

Posted on May 4, 2009. Filed under: extreme networks |

Loopback Detection

Each port may enable loop detection. This optional feature detects that a port has been looped back to the local system. If a loopback is detected, the port is disabled. Note that loopbacks may exist between different ports. The feature will disable any port that both has the feature enabled, and receives an LACP message that was sent from the local system.

To enable or disable loopback detection, use the following commands:

enable lbdetect port <portlist> [retry-timeout<seconds>]

disable lbdetect port <portlist>

Advertisements
Read Full Post | Make a Comment ( None so far )

Liked it here?
Why not try sites on the blogroll...